Utility Display Operation; Info Page - Yamaha DME64N - Pro Audio Owner's Manual

Utility Displays

Utility Display Operation

The general procedure for operating the Utility displays is
outlined below.
1.
Press the [UTILITY] key for longer than
2 seconds from the Main display to go to the
Utility display.
2.
Press the [UTILITY] key as many times as
necessary until the desired parameter page
appears.
3.
Use the cursor keys – [
select the parameter you want to edit.
NOT E
On the ICP1 the function buttons are used in place of the cursor
keys as follows:
[F1] key: Left
[F2] key: Up
[F3] key: Right
[F5] key: Down
4.
Press the [ENTER] key.
This either confirms a selection or edit, or calls the
appropriate parameter edit page.

Info Page

1
2
3
4
NOT E
The date and time (3) and the internal battery status (4) are
not shown on the ICP1 control panel display.
1 Label
Shows the name. The name can be changed via the DME
Designer application running on a computer connected to
the unit.
NOT E
The name can not be changed from the DME64N/24N controls.
2 Program Version
This is the current firmware version number.
46
DME64N/DME24N Owner's Manual
E ] [ ▲ ] [ ▼ ] [ F ] – to
5
3 Date
Shows the currently set date and time. The internal clock
and calendar can be set here.
Edit using the "Numeric Parameters" editing procedure
described on page 36.
N OTE
"Zone slave" cannot be used to set this parameter.
Date/Time Parameter Edit Dialog
Day - Month - Year
4 Battery
Shows the status of the internal battery. "Low Battery" will
appear when the battery needs to be replaced, and "No
Battery" will appear when no battery is present in the
device.
5 Daylight Saving Time
If you enable daylight saving time, the display will indicate
"DST."
You can enable daylight saving time using DME Designer
from a connected computer.
N OTE
Daylight saving time cannot be set on the DME64N/24N itself.
Hour : Minute : Second