Ethernet Connection ([Network] Connector) - Yamaha 1009MWTO-F0 Owner's Manual

Ethernet Connection ([NETWORK] Connector)

To control the DME64N/24N from the computer via Ethernet, use an Ethernet cable to connect the [NET-
WORK] connector on the rear panel of the DME64N/24N to the computer, then install DME-N Network Driv-
er.
NOTE
the "DME Setup Manual" (PDF file)
• Refer to
• Appropriate IP addresses must first be assigned to all devices connected to an Ethernet network.
Two DME series units directly connected via Ethernet
You can connect devices in the same device group directly to each other using Ethernet cables, without
connecting them to a network switch.
A cross cable or straight cable can be used since the DME series supports Auto MDI/MDI-X. In this case,
set Link Mode on both units to the same setting. Devices in different subnet (different network address)
groups can be connected via a router or layer-3 compliant network switch.
for details on installing DME-N Network Driver.
SCENE SCENE HOME HOME UTILITY UTILITY LEVEL LEVEL MUTE MUTE CANCEL CANCEL ENTER ENTER
DME64N/24N
Ethernet Cable
INPUT
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL DIGITAL MIXING ENGINE SATELLITE
USB
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
INPUT
DME Satellite
Ethernet Connection ([NETWORK] Connector)
USB Cable
DME64N/DME24N Owner's Manual 23