Processor - HP AX691B Maintenance And Service Manual

Remove all power supplies
3.
Remove the server from the rack (on page 27).
4.
Remove the access panel
5.
Remove the PCI riser cage
6.
Remove the air baffle
7.
Remove the power supply backplane
8.
Loosen the system board thumbscrews, and then slide the system board assembly forward.
9.
Remove the power supply cage assembly.
10.
To replace the component, reverse the removal procedure.

Processor

CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
multiprocessor configurations must contain processors with the same part number.
IMPORTANT:
the server does not power up.
To remove a processor:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Remove the access panel
3.
Remove the PCI riser cage
4.
Remove the air baffle
5.
("Hot-plug power
("Access panel" on page 30).
("PCI riser cage" on page 41).
("Air baffle" on page 42).
("Power supply
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment,
Processor socket 1 must always be populated. If processor socket 1 is empty,
("Access panel" on page 30).
("PCI riser cage" on page 41).
("Air baffle" on page 42).
supply" on page 32).
backplane" on page 35).
Removal and replacement procedures 54