Extend The Server From The Rack - HP AX691B Maintenance And Service Manual

NOTE:
step.
Press the Power On/Standby button to place the server in Standby mode. When the server activates
3.
Standby power mode, the system power LED changes to amber.
IMPORTANT:
panels. In a rack environment, this feature facilitates locating a server when moving between
the front and rear of the rack.
Disconnect the power cords.
4.
The system is now without power.

Extend the server from the rack

Pull down the quick release levers on each side of the server.
1.
Extend the server from the rack.
2.
WARNING:
is adequately stabilized before extending a component from the rack.
After performing the installation or maintenance procedure, slide the server back into the rack, and
3.
then press the server firmly into the rack to secure it in place.
WARNING:
release latches and sliding the server into the rack. The sliding rails could pinch your fingers.
If the operating system automatically places the server in Standby mode, omit the next
Pressing the UID button illuminates the blue UID LEDs on the front and rear
To reduce the risk of personal injury or equipment damage, be sure that the rack
To reduce the risk of personal injury, be careful when pressing the server rail-
Removal and replacement procedures 26