SAS hard drive blank
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
Remove the component as indicated.
To replace the blank, slide the blank into the bay until it locks into place.
Hot-plug SAS hard drive
To remove the component:
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations
1.
SATA hard drive LED
Back up all server data on the hard drive.
2.
Remove the hard drive.
3.
To replace the component, reverse the removal procedure.
Power supply blank
To remove the component:
For proper cooling do not operate the server without the access panel, baffles,
For proper cooling do not operate the server without the access panel, baffles,
combinations" on page 86).
Removal and replacement procedures 31
("SAS and