Potential Problems - Konica Minolta DR1600 Operator's Manual

POTENTIAL PROBLEMS

When any error message occurs in the Microfilmer, an error message appears on the display, the Shutter Button
turns red, and microfilm advancing stop. In this case, check the error code (numbers following the letter "E") and
call your authorized Service Representative.
Error Code
E-01 Film Unit Mounting Board malfunction
E-02 Electrical Circuit Board to the inside of a Copy
Board malfunction
29
Possible Cause Description
Since a Film Mounting Board does not move up
and down, a Reduction Ratio setting of a Camera
cannot be performed. For the reason, a
Microfilmer does not operate, either.
The memory function of the Main Control Board is
destroyed. Therefore, a setup of various data or
conditions cannot be performed. However, a Stop
Key can cancel an Error display and a film frame
advancing can be continued. If a Power Switch
turned OFF carried out, various data and the
setting conditions are cleared. In order to record
data, please be sure to contact to your authorized
Service Representative before turn off.