Denso BHT-6000 User Manual page 68

(3) Character length screen
SET DATA BIT
< CONNECTOR >
1:7 bits
2:8 bits
(4) Stop bit length screen
SET STOP BIT
< CONNECTOR >
1:1 bit
2:2 bits
(5) Communications protocol option menu
SET PROTOCOL
< CONNECTOR >
1:SERIAL No.
2:H.PARITY
3:LINKUP TIME
4:FIELD SPACE
Chapter 2. Getting Started the BHT-6000 and System Mode
Selecting "3:DATA BIT" on the SET CONNECTOR
screen calls up the screen shown at left.
Select the desired character length by using the
numerical keys or F5 and F6 keys, and then
press the ENT key.
To return to the SET CONNECTOR screen, press
the C key.
Selecting "4:STOP BIT" on the SET CONNECTOR
screen calls up the screen shown at left.
Select the desired stop bit length by using the
numerical keys or F5 and F6 keys, and then
press the ENT key.
To return to the SET CONNECTOR screen, press
the C key.
Selecting "5:PROTOCOL" on the SET CONNECTOR
screen calls up the screen shown at left.
1 SERIAL No.:
2 H. PARITY:
3 LINKUP TIME:
4 FIELD SPACE:
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET CONNECTOR screen, press
the C key.
If the BHT-Ir protocol has been selected, the
NOTE
serial number and horizontal parity settings
will be ignored.
53
Switches to the serial number
ON/OFF screen.
Switches to the horizontal
parity ON/OFF screen.
Switches to the timeout
length screen.
Switches to the space code
handling screen.