Denso BHT-6000 User Manual page 110

Phase 2 with NAK
If the sending station receives a NAK from the receiving station in response to a
transmission block containing text data m, it sends that transmission block again
immediately as shown below.
If the sending station receives an ACK before receiving a NAK 10 times in succes-
sion, it continues the subsequent message transmission.
If the sending station receives a NAK 10 times in succession or it fails to send a
same transmission block, it shifts to phase 3 to terminate the message transmis-
sion abnormally. Even if the phase 3 terminates normally, the transmission results
in an abnormal end.
Chapter 3. Communications Operations of BHT-6000
Sending
Data text m
station
NAK
Data text m
NAK
Data text m
ACK
Data text m+1
Sending
station
Data text m (1)
NAK
Data text m (2)
NAK
Data text m (10)
NAK
Occurrence
of an error
To phase 3.
95
Receiving
station
Receiving
station