Denso BHT-6000 User Manual page 64

SET COM
1:OPTICAL
2:CONNECTOR
3:COM PORT
4:PROTOCOL TYPE
[4.6-1] Setting the communications parameters for the optical interface
SET OPTICAL
1:TRANSMIT SPEED
2:PULSE WIDTH
3:PROTOCOL
Chapter 2. Getting Started the BHT-6000 and System Mode
Selecting the "6: COM" on the SET SYSTEM menu
calls up the screen shown at left.
1 OPTICAL:
2 CONNECTOR:
3 COM PORT:
4 PROTOCOL TYPE:
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET SYSTEM menu, press the C
key.
Selecting "1:OPTICAL" on the SET COM menu calls
up the screen shown at left.
1 TRANSMIT SPEED:
2 PULSE WIDTH:
3 PROTOCOL:
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET COM menu, press the C key.
49
Switches to the communi-
cations parameters setting
screen for the optical inter-
face .
Switches to the communi-
cations parameters setting
screen for the direct-con-
nect interface.
Switches to the interface
port setting screen.
Switches to the communi-
cations protocol type set-
ting screen.
Switches to the transmis-
sion speed screen.
Switches to the IR beam
output pulse
screen.
Switches to the commu-
nications protocol option
menu.
width