Table of Contents
Advertisement
10 SURROUND
Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment
can be performed with the system setup (see page 23) or from the remote control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the DOLBY/DTS
SURROUND and HOME THX CINEMA modes. The adjusted levels for the different modes are automatically stored in the memory.
1
(Remote control unit)
2
(Remote control unit)
3
(Remote control unit)
• After adjusting using the test tones, make the desired settings for each surround mode to be played, then use the procedure described below
to adjust the levels of the various channels.
1
MAIN UNIT:
Press the CH VOL button and select
"CH VOL".
REMOTE CONTROL UNIT:
Select the speaker whose level you want
to adjust.
The channel switches in the following
order each time the button is pressed:
FL
C
FADER
2
MAIN UNIT:
Turn the SELECT knob to adjust the
level of the selected speaker.
REMOTE CONTROL UNIT:
Adjust the level of the selected speaker.
56
Press the TEST TONE button.
Test tones are output from the
different speakers. Use the channel
volume adjust buttons to adjust so
that the volume of the test tones is
the same for all the speakers.
After completing the adjustment,
press the TEST TONE button again.
CH VOL
(Main unit)
(Remote control unit)
FR
SR
SBR
SBL
SW
SL
SELECT
(Main unit)
(Remote control unit)
1, 3
1
When the surround back speaker setting is set to "1spkr" for
"Speaker Configuration", this is set to "SB".
2
2
1
2
2
2
Hide quick links:
Advertisement
Table of Contents
