Before Setting Up The System; Setting The Type Of Speakers - Denon AVR-4802R Operating Instructions Manual

Before setting up the system

1
Check that all the connections are correct,
ON / STANDBY
then turn on the main unit's power.
(Main unit)
2
Display the System Setup Menu.

Setting the type of speakers

• The composition of the signals output to the different channels and the frequency response are adjusted automatically according to the
combination of speakers actually being used.
1
2
3
4
18
At the System Setup Menu select "Speaker Configuration".
Switch to the speaker configuration screen.
Set whether or not speakers are
connected and, if so, their size
parameters.
• To select the speaker
• To select the parameter
Enter the setting.
a) If no surround speakers are used (if "None" is set for both A and B):
The Crossover Frequency screen reappears.
b) If both surround speakers A and B are used (if either "Large" or "Small" is set for both A and B):
The surround speaker setting screen appears.
c) When "Front" is set to "Large" and "Subwoofer" is set to "Yes", the subwoofer mode screen reappears.
d) If "None" is set for surround speakers A:
"None" is automatically set for surround speakers B and surround back speaker.
1
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
Surround back Sp.
Surround Sp. B