Hole Punch Adjustment - Lexmark 12N0008 - C 910 Color LED Printer User Manual

Hole punch adjustment

Note:
used for both three and four hole punch
finishers.
Bottom edge is
below top edge
44
Troubleshooting
The following procedures are
Bottom edge is
above top edge
You can adjust the hole punch alignment
by approximately 4 mm (
adjustment is useful when you want to
center the punched holes onto the paper
or if you hole punched a printed job on
different finishers.
1
Verify the alignment of the printer
and finisher is correct.
If the alignment is not correct, see
"Aligning the top of the finisher" on
page 15 for instructions, and then
print and hole punch another
sheet of paper and see if an
adjustment is needed.
If an adjustment is needed,
continue with step 2.
2
Using a sheet of paper previously
punched from the finisher, fold the
paper so the bottom punched hole
is aligned with the top punched
hole.
3
Determine if the edge of the
bottom of the page is below or
above the top edge of the page.
3
/ in.). This
16