Mita DP-2800 Instruction Handbook Manual page 97

3. What is the printer name?
Type the desired printer name and press ENTER.
Your screen will now display the information you provided to the install script. For exam-
ple:
Node name of the EcoLAN 1000E: printfast
Printer name to be used:
The printer is attached on: PORT 1
You are asked to OK this configuration. Type yes or no and press ENTER.
4. The script starts the daemon for the newly configured printer automatically. It also
displays the path used should you ever need to restart the daemon. In the follow-
ing example, the path would be:
/usr/nic/lpr_print /dev/nic/printer_name printfast 9100 &
This example reflects names supplied to the script earlier.
When the installation script is complete, you must configure the printer and make it
known to the lp system. The HP/UX lp system uses the lpadmin maintenance
command to configure a printer (there is not a /etc/printcap file). The specific
commands to do this are:
lpadmin -p printer_name -v /dev/nic/printer_name
enable printer_name
accept printer_name
You can also use other options for the lpadmin command. See your system
documentation for details.
Note: The printer name must be the same as the one you entered during the EcoLAN
1000E installation. HP supplies the sam program as an alternative to configure the
printer.
When using sam, specify everything as if the printer were directly connected
to /dev/lprprinter/printer_name.
<printer_name>
TCP/IP Configuration 7-33