Mita DP-2800 Instruction Handbook Manual page 82

6. Edit the /etc/BOOTPtab file and add the following information:
nic_host:\
:ht = hardware type:\
:ha = ethernet address:\
:ip = IP address:\
:sm = subnet mask:\
:gw = gateway address:
For example, for an RFC 1048 system:
printfast:\
:ht = ether:\
:ha = 0040AF03AF6E:\
:ip = 192.9.200.200:\
:sm = 255.0.0.0:\
:gw = 192.9.200.10:\
If running with a more recent BOOTP implementation, such as with SCO UNIX, add:
:vm = rfc1048:
The same information uses the following format on an RFC 951 system:
host
printfast
7. Start the BOOTP daemon by typing:
bootpd -s
8. Check the printer to verify that the EcoLAN 1000E is connected to the network.
Turn on the printer.
9. Wait until the printer powers up and finishes initializing to allow enough time for
the IP address to become known and to be saved in non-volatile memory. The
EcoLAN 1000E should reinitialize itself.
10. After the EcoLAN 1000E has reinitialize, send a ping command to verify that the
print server obtained its IP address. For example:
ping 192.9.200.200
If the print server has the address, the result is a confirmation message:
192.9.200.200 is alive
TCP/IP Configuration 7-18
htype haddr
1 00:40:af:03:af:6e
iaddr
192.9.200.200
bootfile
defaultboot