Start Pconsole And Select File Server; Create Print Queues - Mita DP-2800 Instruction Handbook Manual

5. Assign the print queues.
6. Set up the NOTIFY options.
7. Repeat the procedure for other file servers.
When you are finished, turn the printer off and on again. The printer creates a status
report that indicates the fileservers to which the unit is attached and the queues which
it services.
Before you begin:
• Verify that you have supervisor privileges on the file servers on which the EcoLAN
1000E print server is to be entered.
• Verify that your version of PCONSOLE is later than 1.0.

4.1.1 Start PCONSOLE and Select File Server

Follow these steps to start PCONSOLE:
1. Log in to the network, type PCONSOLE and press ENTER.
2. Choose Change Current File Server from the Available Options menu. A list of
file servers is displayed.
3. Select the file server on which you want to install the print server and press
ENTER. If the name of the file server you want is not displayed, press the INS
key to get a list of file servers.
4. Log in to the file server.
5. Press the ESC key to return to the Available Options menu.

4.1.2 Create Print Queues

The print server must be assigned to at least one print queue on the file server.
• If the print queue that you want the <EcoLAN 1000E> to service already exists, and
you know the name of this queue, go to 4.1.3 Enter the Print Server Name .
• If you do not know the name of the queue, or it does not exist, use the following
procedure:
1. Choose Print Queue Information from the Available Options menu, and press
ENTER. A list of existing queues is displayed.
2. To create a new queue, press INS. Enter the name of the queue and press ENTER.
You do not need to enter any more information at this time.
3. Press the ESC key to return to the Available Options menu.
NetWare Configuration 4-2