Configure Ip Parameters - Mita DP-2800 Instruction Handbook Manual

4. To end your Telnet session, type E at the Main Menu. If you have made any
changes you are prompted to either Save Changes and Exit or Exit Without Saving
Changes. Choose your option and press ENTER.
Note: Press ? to access the Telnet help utility.

7.4.2 Configure IP Parameters

Although the EcoLAN 1000E must have an IP address before a Telnet Connection can
be made, you can use the utility to change the address or the other IP parameters. The
EcoLAN 1000E will automatically initiate a soft reset when the IP address change is
sensed.
Note: This will cause the Telnet connection to be broken. It is advisable to make all other
desired changes before changing the IP address.
1. At the Main Menu, type 1 and press ENTER to bring up the IP Parameters menu
(shown on the next page).
2. Type 1 again and press ENTER. The IP Address submenu will appear:
3. Enter a new IP Address and press ENTER. Repeat the previous steps to change
Subnet Mask and Default Gateways.
4. Enter 4 to change the base port number.
Note: The base port number is one less than the actual TCP/IP port number used by the
printer. For example, to set the port number to 9100, enter 9099.
The Configuration Utility
Unit Serial no. 221963
1. IP Address
2. Subnet Mask
3. Default Gateway
199.92.187.37
255.255.255.0
199.92.187.254
TCP/IP Configuration 7-41