Mita DP-2800 Instruction Handbook Manual page 149

::= { appleprinterEntry 2 }
-- Default value reproted on
-- However, unit will assunme default value of
appleprinterenable
SYNTAX DisplayString (SIZE(0..8))
ACCESS read-write
STATUS mandatory
DESCRIPTION
"(E)nabled or (D)isabled."
::= { appleprinterEntry 3 }
-- Not Applicable to
is N/A
appleprintertype
SYNTAX INTEGER (0..65535)
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Unused"
::= { appleprinterEntry 4 }
-- NIC response is '0'
appleprinterbidirectional
SYNTAX DisplayString (SIZE(0..3))
ACCESS read-only
STATUS mandatory
DESCRIPTION
"This variable specifies the bidirectional capabilities of
of the Appletalk printer. YES if printer is bidirectional,
NO if not."
::= { appleprinterEntry 5 }
-- NIC response is YES
-- DPI LAT Group
enablelat OBJECT-TYPE
SYNTAX DisplayString (SIZE(0..8))
ACCESS read-write
STATUS mandatory
DESCRIPTION
"This variable specifies whether or not the DEC LAT protocol
is enabled. Changes occur at the next reset or power cycle."
::= { dpilat 1 }
-- NIC response is N/A.
END
NIC is no value, indicating that there is no value in NVRAM
OBJECT-TYPE
NIC, since enable/disbale is on basis of AppleTalk protocol. Response
OBJECT-TYPE
OBJECT-TYPE
'NIC Multiprotocol'
NIC MIB Definition Appendix C-23