Reloading Using The Ftp Protocol From A Command Prompt - Brother HL-1870n Network User's Manual

APPENDIX
Reloading using the FTP Protocol
from a command prompt
By specifying the print server PASSWORD AS THE USERNAME when
logging on, it becomes possible to upgrade the firmware of the print server or
printer (if supported). The following example assumes that the print server
password is "cambridge"
D:\>ftp
ftp> open 220.0.250.200
Connected to 220.0.250.200.
220 FTP print service:V-1.05/Use the network password
for the ID if updating.
User (220.0.250.200:(none)): cambridge
230 User cambridge logged in.
ftp> bin
200 Ready command OK.
ftp> hash
Hash mark printing on ftp: (2048 bytes/hash mark) .
ftp> send brnt261.blf
200 Ready command OK.
150 Transfer Start
######################################################
###
######################################################
######################################################
######################################################
############
226 Data Transfer OK/Entering FirmWareUpdate mode.
ftp: 1498053 bytes sent in 8.52Seconds
175.77Kbytes/sec.
ftp> close
226 Data Transfer OK.
ftp> quit
When you see "226 Data Transfer OK/Entering FirmWareUpdate mode." You
can be sure that the firmware file is being transferred to the print server. If you do
not see this message, the file you are sending to the printer will either be ignored
or the printer will print garbage.
You must use the "bin" command to put the FTP client into Binary
communications mode. If you do not specify the bin command the upgrade
process will not function correctly.
A-7