Eliminating Blank Pages - Brother HL-1870n Network User's Manual

5. You are now ready to print. Use the PRINT command with the name of
the queue and the file you wish to print as shown in the following
example:
PRINT/QUEUE=BRN MYFILE.TXT
If the file does not print, recheck the hardware and software configuration, and
then try printing again. If the file still does not print, refer to the
portion of this userguide for further assistance.

Eliminating Blank Pages

When printing through VMS, a blank page is often printed after each job. To
eliminate this blank page, first create a text file with the following contents:
<ESC>]VMS;2<ESC>\
where <ESC> is the escape character (ASCII 27) and "VMS" is in uppercase.
Then insert this file into your default library (normally SYSDEVCTL.TLB), and
specify it as a setup module in your form (stop and reset all queues that use the
library before doing this procedure). For example:
$LIB/INS SYS$SYSROOT:[SYSLIB]SYSDEVCTL.TLB NOBL
$DEF/FORM PCL/SETUP=NOBL
The above example inserts the file NOBL.TXT into the default library and then
redefines the form PCL (previously defined in step 4) to eliminate blank pages.
This procedure is not required for DECprint Supervisor (DCPS).
CHAPTER 9 LAT NETWORK CONFIGURATION
9-4
Troubleshooting