Mode) Using Bradmin - Brother HL-1870n Network User's Manual

Configuring the Brother Print Server
(Queue Server Mode in Bindery
emulation mode) using BRAdmin
1. Make sure that you logged in as SUPERVISOR (NetWare 2.xx or 3.xx)
or ADMIN (NetWare 4.xx or later).
2. Start BRAdmin.
3. One or more print server will appear in the list (the default node names
are BRN_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet
address (MAC address)).
You can find the node name and MAC address by printing out the printer
configuration page. Refer to the User's Guide for information on how to printer
the configuration page on your print server.
4. Select the print server that you wish to configure and double click it.
You will be asked for a password. The default password is "access".
5. Select the NetWare tab.
If necessary change the "Print Server Name", the default NetWare print server
name will usually be BRN_xxxxxx_P1 where xxxxxx is the Ethernet address of
the print server. Be careful! Changing the name may impact the configuration of
other protocols because the print server service names will be altered.
a. If it is not already selected, select Queue Server mode.
b. Click the Change Bindery Queues button.
c. Select the NetWare server which you wish to configure.
d. Select the New Queue button and type in the queue name which you
wish to create.
e. Once you have done that highlight the queue name you created and
click on the Add button.
f. Click on Close and then OK.
Now exit the BRAdmin application. You are ready to print.
CHAPTER 6 NOVELL NETWARE PRINTING
6-6