Reloading Using The Ftp Protocol From A Command Prompt - Brother MFC-822 Network User's Manual

5
Netware GET from a server
You must have a Netware server on your network (running IPX/
SPX) and you must store the new firmware file in the SYS/Login
directory of the server. In this case, your PC makes the Print/Fax
server read the firmware data from the assigned Netware
server, the Print/Fax server attaches to the Netware server and
reads the firmware itself.
After sending firmware to the machine, do not turn off the
machine until after the machine has performed an automatic
restart.
Reloading using the FTP Protocol from a
command prompt
By specifying the Print/Fax server password as the username when
logging on, it becomes possible to upgrade the firmware of the Print/
Fax server or printer (if supported). The following example assumes
that the Print/Fax server password is cambridge
D:\>ftp
ftp> open 220.0.250.200
Connected to 220.0.250.200.
220 FTP print service:V-1.05/Use the network
password for the ID if updating.
User (220.0.250.200:(none)): cambridge
230 User cambridge logged in.
ftp> bin
200 Ready command OK.
ftp> hash
Hash mark printing on ftp: (2048 bytes/hash mark) .
ftp> send brnt261.blf
200 Ready command OK.
150 Transfer Start
#################################################
########
#################################################
#################################################
#################################################
###########################
226 Data Transfer OK/Entering FirmWareUpdate mode.
ftp: 1498053 bytes sent in 8.52Seconds
175.77Kbytes/sec.
ftp> close
226 Data Transfer OK.
ftp> quit
A - 6 APPENDIX