How To Change The Factory Settings - US Robotics 002605-00 Manual

P
ART
down on the first page of this manual. Go to
"How to Insert the Modem" on page 19.
How to Change the Factory
Settings
(NOTE: If ComTest recommended
COM2/IRQ3 for your modem, you can
skip this section.)
1.
Always touch an unpainted metal part of
your computer (the back is usually
unpainted) to discharge static electricity
before handling the modem. Static can
damage your modem.
2.
Take the modem out of its plastic bag.
3.
Find the COM port and IRQ shunts (small
black plastic pieces) on your modem. They
should be in roughly the area indicated in
the following illustration.
16
I: S A: I
ECTION NTERNAL
M I
ODEM NSTALLATION WITH
4.
To change the COM port and IRQ settings,
you must move the shunts on the COM
port and IRQ pins. To do this, lift the shunts
off the pins.
W 3.
INDOWS X