Table of Contents
Advertisement
Order of setup
The ND 1200 setup software is contained on up to 18 screens,
depending on the hardware configuration. It is possible that not all the
setup screens described in this chapter are active in your system.
Disregard screen descriptions that do not apply to your ND 1200.
The initial ND 1200 setup tasks should be performed in the order listed
here. Instructions are presented in this order on subsequent pages.
Initial setup tasks
1: Language selection and product version information
2: Supervisor password entry and program unlocking
3: Encoder configuration
4. Loading settings files and startup screens (instead of manual setup)
5: Optical edge detection setup (optional)
6: Stage squareness calibration
7: Error correction
8: Measurement scaling for parts that expand or shrink
9: Measurement configuration
10: Display formatting
The additional setup tasks can be performed in any order.
Remaining setup tasks
Hot key assignments
Print formatting
RS-232 Port configuration
USB port configuration
Audio configuration
Key repeat delay
Time and date
ND 1200 setup configurations can be saved on USB drives
Saving settings
Saving settings files and ND 1200 programs
88
Setup screens
About
Supervisor
Encoders and Misc
Supervisor
Misc screen and Edge soft key menu
Squareness
LEC, SLEC or NLEC screen
Scale factor
Measure
Display
Setup screens
Hot keys
Print and Form characters screens
RS-232
USB
Sounds
Misc
Clock
Setup screens
Supervisor
2 Installation and Specifications
Advertisement
Table of Contents
