Advertisement
Quick Links
IARMOR EDGE™
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE
PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION. ASSISTANCE IS RECOM-
MENDED. THANK YOU FOR CHOOSING OUR PRODUCT!
*ROCKER PANEL MOUNT
*DRILLING NOT REQUIRED
PART LIST
Driver Side Step Bar
Pedal
Drain
Hole at
Bottom
iArmor
1#
1#
Note:
Step bars are NOT interchangeable. Make
sure drain holes at the bottom will be located at
the rear direction of the step bars.
Customer Support: info@iarmorauto.com
Torque Value
Fastener Size
6mm
8mm
10mm
12mm
14mm
Front
1
®
PART#: IA-N010H
Tightening Torque (ft-lbs)
6-7
16-18
31-32
56-58
92-94
Passenger Side Step Bar
2#
2#
Drain
Hole at
Bottom
Rev. 20221201
Required
X
√
X
X
X
Pedal
Advertisement
Related Manuals for APS IARMOR EDGE IA-N010H
Summary of Contents for APS IARMOR EDGE IA-N010H
- Page 1 iArmor ® IARMOR EDGE™ PART#: IA-N010H Torque Value BEFORE INSTALLATION Fastener Size Tightening Torque (ft-lbs) Required REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOM- 16-18 √ MENDED. THANK YOU FOR CHOOSING OUR PRODUCT! 10mm 31-32 *ROCKER PANEL MOUNT...
- Page 2 iArmor ® Hardware Package A (For Brackets & Bars Installation) Item Description Item Description Driver Front / Rear Mounting Brackets M8X1.5 Nylon Lock Nuts Passenger Front / Rear Mounting Brackets M8 Clip Nuts M8X1.25-25 Hex Bolts M8X1.25-20 T-Bolts M8 Large Flat Washers M8 Plastic Washers M8 Lock Washers Hardware Package B (For Step Pedals Installation)
- Page 3 iArmor ® The instruction here is for your reference only. We strongly recommend the professional installer for best result. We are not responsible for any damage caused by the installation. STEP 1 Install (2) Pedals onto the step bars with (12) M8X1.25-25mm Hex Bolts, (12) M8 Large Flat Washers and (12) M8 Lock Front Washers.
- Page 4 iArmor ® STEP 4 STEP 6 Once all (2) brackets have been installed, select (4) M8X1.25- Attach the Passenger Front Mounting Bracket onto the in- 20mm T-Bolts, thread (1) M8 Plastic Washer on each T-Bolt, stalled M8 Clip Nut with (1) M8X1.25-25 Hex Bolt and (1) M8 (Fig 6).
- Page 5 iArmor ® STEP 8 Attention Do periodic inspections to the installation to make sure Level and adjust the assembled Step Bar properly and tighten that all hardware is secure and tight. all hardware. In order to protect your bars/boards, please use mild Move to the other side of the vehicle.
Need help?
Do you have a question about the IARMOR EDGE IA-N010H and is the answer not in the manual?
Questions and answers