Xerox C8 - DocuPrint Color Inkjet Printer User Manual page 330

316
Make sure that the green light on the X-Rite DTP32HS is on and
9.
blinking. Center the cyan column under the alignment mark on the
densitometer.
Slowly insert the Image Start Points Calibration Chart to the X-Rite
10.
DTP32HS densitometer until it is automatically advanced by the
densitometer motor.The green light slowly flashes while the chart is
pulled through the densitometer and out the back.
A beep sounds and a green light blinks when the scan is complete. A
check mark appears over the cyan icon and instructions appear for the
next sweep, this time for the magenta column.
After each color sweep, wait for the check mark to appear over the
11.
appropriate icon and follow the instructions as listed.
Note: Ensure that the separation columns on the Continuous Tone Chart
are scanned in the order they appear in the icons:
Cyan>Magenta>Yellow>Black.
When all of the separation columns have been successfully scanned, a
check mark appears next to all icons.
Notes:
•
If at any stage the scanning has not been completed properly, click
Reset and scan again.
•
If an error occurs while you are scanning the chart, an alert message
appears. Click OK and re-scan the charts.
Chapter 7 – Color Workflow