Table of Contents
Advertisement
2. Press the UTILITY button.The Utility button's LED lights.
3. Use the PREV or NEXT buttons to select
4. Use the DATA WHEEL to select the Amp number you want to dump.
5. Press the STORE button. The display will read
6. Use the DATA WHEEL to select the destination User Amp number.
7. Set the MIDI recording device to record.
8. Press the STORE button again. The display will read
time the display returns to
9.When finished, press EXIT.
NOTE: Amp Dump sends information on the MIDI channel defined in the MIDI Channel
Menu.
MIDI Mapping
MIDI Mapping provides access to all factory and user presets from external MIDI program change
commands that may not correspond to the GNX4 preset. This is useful when multiple MIDI devices are
chained together and controlled by one central unit. For example, the main MIDI controller can send out
a program change command telling a particular MIDI unit to change to Program 10, but you may want the
GNX4 to change to User Preset 27. You can remap the GNX4 so when it receives MIDI Program change
10, it calls up User Preset 27. The Procedure for mapping MIDI program changes is as follows:
1. Press the UTILITY button.The Utility button's LED lights.
2. Use the PREV or NEXT buttons to select
3. Use the DATA WHEEL to select the incoming MIDI program number you want to remap. The
flashing number to the right of the
4. Press the NEXT button. The number in the red numeric display begins flashing. This number
represents the GNX4 preset number that is selected when the GNX4 receives the MIDI program
number shown to the right of the
5. Rotate the DATA WHEEL to select the preset number the GNX4 will use when it receives the
selected MIDI program change.
6.When finished, press EXIT.
MIDI Merge
The MIDI Merge function echoes the incoming MIDI data to the MIDI Out port of the GNX4. This is
useful when multiple MIDI devices are chained together, and you want to pass incoming MIDI Data on to
MIDI devices downstream from the GNX4.The procedure for enabling or disabling the MIDI Merge
function is as follows:
1. Press the UTILITY button located in the Control Panel. The Utility button's LED lights.
2. Use the PREV or NEXT buttons to select
the current MIDI Merge status
3. Use the DATA WHEEL to select the status.
4.When finished, press EXIT.
Drum MIDI
The GNX4's drum machine uses standard Type 0 MIDI files for each of its internal patterns. This MIDI
information can be transmitted out the GNX4's MIDI output and up to the computer via USB. You can
enable or disable these MIDI messages from being transmitted out these ports. Disabling these MIDI
messages resolves the issue of having messages that are sent from the GNX4 being echoed by the
computer back to the GNX4 and erroneously retriggering the drums if the drums are on. To enable or
disable the drum pattern MIDI messages from being transmitted, follow these steps:
.
increases and decreases as you turn the DATA WHEEL.
in the alpha-numeric display.
On
OF
or
.
(Amp Dump).
.
until the dump is complete at which
(MIDI Mapping).
(MIDI Merge). The red numeric display reflects
Utilities
107
Advertisement
Table of Contents
