Table of Contents
Advertisement
Utilities
1. Press the UTILITY button. The button will light indicating you are in the Utility menu.
2. Use the PREV or NEXT buttons to select
current Drum MIDI status
3. Use the DATA WHEEL to enable or disable transmission of the drum pattern MIDI messages.
4.When finished, press EXIT.
Default Drum Kit
Each drum machine pattern in the GNX4's drum machine has a default drum kit assigned to it when the
pattern is played. This default kit can be disabled so that all patterns may be auditioned with the same kit
without having to re-select the kit each time the pattern is changed. To enable or disable the default kit
feature, follow these steps:
1. Press the UTILITY button located in the Control Panel.
2. Use the PREV or NEXT buttons to select
from the factory.
3. Use the DATA WHEEL to enable (
4.When finished, press EXIT.
Factory Reset
This function resets the GNX4 to its original factory settings. This procedure erases ALL custom user
presets, utility settings, and re-calibration of the Expression Pedal. The procedure for performing a
Factory Reset is as follows:
NOTE: Performing this function will erase all user-programmed data. Be sure you want to
erase the memory and start fresh before continuing with this procedure. A factory
reset does not erase any of the content on a Compact Flash card if installed in the
GNX4.
1. Press the UTILITY button.The Utility button's LED lights.
2. Use the NEXT button to select
NOTE:This procedure resets ALL user settings. Press the EXIT button now to abort the
factory reset function.
3. Press the STORE button once and the display will show
4. Press the STORE button again and the display will display
recalibrate the Expression Pedal at this time.
5.While the display reads
flashing Footswitch 4.
6.When the display reads
Footswitch 5. The display will then read
V-Switch.
7. Press the Expression Pedal forward firmly as if activating a wah pedal and then rock it back. The display
will now read
Expression Pedal firmly forward a couple of times. The V-Switch LED next to the DATA WHEEL
should turn on and off. If you find the V-Switch is too easy or to difficult to engage, you can adjust the
V-Switch value higher (makes it harder to engage) or lower (makes it easier to engage). The Range is
to
. Above
8.When finished, press EXIT.
108
On
OF
or
.
On
) or disable (
, rock the Expression Pedal forward (toe down) and then press the
, rock the Expression Pedal back (toe up) and press the flashing
, which is the default sensitivity. Test the V-Switch by pressing the
the V-Switch can be set to OFF to disable it.
(Drum MIDI). The red display reflects the
(Default Drum Kit). This feature is turned on
Of
) this feature.
(Reset) and the STORE button will begin to flash.
which is a prompt for you to calibrate the
.
and then
. You must
Advertisement
Table of Contents
