Table of Contents
Advertisement
About the GNX4
Bypass
The GNX4 presets can be bypassed for a clean, unprocessed guitar tone. Bypass turns off all effects and
modeling. To bypass the GNX4 in Preset Mode, press the active preset's Footswitch (the 1-5 footswitch
that is lit), or press Footswitches S 2 and 3 simultaneously. To bypass the GNX4 while in
Stompbox/Control or Recorder Mode, press Footswitches 2 and 3 simultaneously. When the GNX4 is
bypassed, the display reads
and all LEDs in the Matrix are off. Press any Footswitch to exit Bypass
and return to the last preset. The Matrix and Programming buttons do not function when Bypass is activated.
NOTE: If Preset Bounceback is enabled in the Utility menu, pressing the active preset's
footswitch while in Bank Mode will not bypass the GNX4's effects. To bypass the GNX4's
presets while Preset Bounceback is enabled you must press Footswitches 2 and 3
simultaneously.
Tuner
The Tuner in the GNX4 lets you quickly tune or check the tuning on your guitar. Press Footswitches 3 and
4 simultaneously to access the Tuner. The display briefly flashes
. To begin tuning, play a note on your
guitar (a harmonic at the 12th fret usually works best).The red numeric display shows the note being played,
and the green alpha-numeric display indicates whether the note is sharp or flat. Arrows to the left (
)
indicate the note is sharp and should be tuned down. Arrows to the right (
) indicate the note is flat and
should be tuned up. When your note is in tune,
is displayed.
While the tuner is selected, you can set your tuning reference with the DATA WHEEL. The default factory
setting is A=440 Hz. The tuning references range from 427 Hz to 453 Hz (± 50 cents (1/2 semitone) from
either direction of 440 Hz). Below 427 Hz, are alternate dropped tunings. The alternate tunings are
REF A(A=Ab), REF G(A=G), and REF G(A=Gb). The display window briefly flashes the selected tuning
preference.
23
Advertisement
Table of Contents
