Creating a Preset
Adjust the Noise Gate
For our example, we want our Noise Gate to open quickly with a relatively weak signal. This type of
gate uses the Silencer
do the following:
1. Press the AMP FOOTSWITCH to select the Channel 2 Amp (
(The GNX4 must be in Stompbox/Control mode to complete this function.)
2. Press the EFFECT SELECT DOWN button and the Noise Gate's LED lights.
3. If the display reads off (
4. Rotate Knob 1 until the display reads
5. Rotate Knob 2 to set the Threshold to
guitar).
6. Rotate Knob 3 to set the Attack Time to
Select and Adjust the Chorus
Next we wanted to thicken up the sound, by adding a subtle Chorus effect, in the following manner:
1. Press the EFFECT SELECT DOWN button again and the LED in the Chorus/Mod row lights.
2. If the display reads off (
3. Rotate Knob 1 until the display reads Chorus (
4. Rotate Knob 2 to set the Chorus Speed to .
5. Rotate Knob 3 to set the Chorus Depth to
6. Rotate Knob 4 to set the PreDelay to
7. Rotate Knob 5 to set the Chorus Level to
Turn the Delay Off
To bypass the Delay, do the following:
1. Press the EFFECT SELECT DOWN button until the LED in the Delay row lights.
2. If the display reads on (On), press the STATUS button until the display reads off (Of).
56
™
with a low threshold and short attack time. To create this type of Noise Gate,
Of
), press the STATUS button until the display reads on (
Of
), press the STATUS button until the display reads on (
1
.
for the type of gate.
(this may need to be adjusted depending upon your
0
(fast attack).
) for the effect type.
30
.
50
.
), our high gain model.
On
).
On
).