Table of Contents
Advertisement
Introduction
Quick Start
This Quick Start section is included for those of you who would rather play now and read later.
Make Connections
1. Connect your instrument to the GUITAR/INSTRUMENT INPUT jack on the GNX4's rear panel.
2. Connect either the 1/4" or the XLR LEFT/RIGHT OUTPUTS to the input(s) of your amplifier(s),
power amp, or mixer.
Speaker Compensation
The GNX4 is equipped with SPEAKER COMPENSATION filtering that can be used with its 1/4",
XLR, and HEADPHONE OUTPUTS.
1. If you are using the GNX4 with headphones or connecting it directly to a mixer via the XLR
OUTPUTS, switch the XLR OUTPUTS' SPEAKER COMPENSATION on. The switch is
located to the right of the XLR jacks on the rear panel.
2. If you are connecting the GNX4 directly to a guitar amplifier with a built-in speaker via the 1/4"
OUTPUTS, switch the 1/4" OUTPUTS' SPEAKER COMPENSATION off. The switch is
located to the right of the 1/4" jacks on the rear panel.
Apply Power
1.Turn the OUTPUT level knobs (for both the 1/4" and XLR OUTPUTS), on the rear panel of the
GNX4, all the way down (fully counter clockwise).
2. Connect the PSS3 power supply to the POWER jack on the GNX4.
3. Connect the other end of the PSS3 power supply to an AC outlet.
4.Turn the GNX4 POWER switch on.
5.Turn your amplifier(s) on, and adjust the volume(s) to a normal playing level. Gradually turn up the
GNX4's OUTPUT level.
Select an Output Setup Mode
1. Press the OUTPUT SETUP button located in the control panel to the right of the DATA WHEEL.
2. Rotate the DATA WHEEL to select an Output Setup mode.
3. Select the Output Setup mode that applies to your application, they include:
,
Note: See page 9 for a detailed explanation of the Output Setups.
5. Press the EXIT button located in the control panel.
Select a Preset
The GNX4 comes with 80 pre-programmed Factory Presets, and 80 User Presets. From the factory, the
User Presets are exact duplicates of the Factory Presets.
1. Press the UP/DOWN footswitches to select a Bank.
2. Press Footswitches 1-5 to select a preset, or rotate the DATA WHEEL.
2
,
and
.
,
,
Advertisement
Table of Contents
