Chapter 20 Remote Management
20.5 Telnet Screen
To change your NBG5715's remote management settings, click Management > Remote MGMT >
Telnet to open the Telnet screen.
Figure 91 Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Table 66 Management > Remote MGMT > Telnet
LABEL
Port
Access Status
Secured Client IP
Address
Apply
Cancel
154
DESCRIPTION
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the interface(s) through which a computer may access the
NBG5715 using this service.
Select All to allow all computes to access the NBG5715.
Otherwise, check Selected and specify the IP address of the computer
that can access the NBG5715.
Click Apply to save your customized settings and exit this screen.
Click Cancel to begin configuring this screen afresh.
NBG5715 User's Guide