Packet Statistics - ZyXEL Communications NBG-5715 User Manual

Chapter 5 Monitor and Summary

5.5 Packet Statistics

Click Monitor > Packet Statistics or the Packet Statistics (Details...) hyperlink in the Status
screen. Read-only information here includes port status, packet specific statistics and the "system
up time". The Poll Interval(s) field is configurable and is used for refreshing the screen.
Figure 15 Summary: Packet Statistics
The following table describes the labels in this screen.
Table 10 Summary: Packet Statistics
LABEL
Port
Status
TxPkts
RxPkts
Collisions
Tx B/s
Rx B/s
Up Time
System Up Time
Poll Interval(s)
Set Interval
Stop
40
DESCRIPTION
This is the NBG5715's port type.
For the LAN ports, this displays the port speed and duplex setting or Down
when the line is disconnected.
For the WAN port, it displays the port speed and duplex setting if you're using
Ethernet encapsulation and Idle (line (ppp) idle), Dial (starting to trigger a
call) and Drop (dropping a call) if you're using PPPoE or PPTP encapsulation.
This field displays Down when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is
enabled and Down when the WLAN is disabled.
This is the number of transmitted packets on this port.
This is the number of received packets on this port.
This is the number of collisions on this port.
This displays the transmission speed in bytes per second on this port.
This displays the reception speed in bytes per second on this port.
This is the total time the NBG5715 has been for each session.
This is the total time the NBG5715 has been on.
Enter the time interval in seconds for refreshing statistics in this field.
Click this button to apply the new poll interval you entered in the Poll
Interval(s) field.
Click Stop to stop refreshing statistics.
NBG5715 User's Guide