ZyXEL Communications NBG-5715 User Manual page 127

Click Security > IPSec VPN to display the Summary screen. This is a read-only menu of your
VPN rules (tunnels). Edit a VPN rule by clicking the Edit icon.
Figure 78 Security > IPSec VPN > General
The following table describes the fields in this screen.
Table 53 Security > IPSec VPN > General
LABEL
#
Status
Local Addr.
Remote Addr.
Encap.
Algorithm
Gateway
Modify
Allow Through
IPSec Tunnel
Apply
Cancel
NBG5715 User's Guide
DESCRIPTION
This is the VPN policy index number.
This field displays whether the VPN policy is active or not.
This icon is turned on when the rule is enabled.
This displays the beginning and ending (static) IP addresses or a (static) IP
address and a subnet mask of computer(s) on your local network behind your
NBG5715.
This displays the beginning and ending (static) IP addresses or a (static) IP
address and a subnet mask of computer(s) on the remote network behind the
remote IPSec router.
This field displays 0.0.0.0 when the Secure Gateway Address field
displays 0.0.0.0. In this case only the remote IPSec router can initiate
the VPN.
This field displays Tunnel or Transport mode (Tunnel is the default selection).
This field displays the security protocol, encryption algorithm and authentication
algorithm used for an SA.
This is the static WAN IP address or URL of the remote IPSec router.
displays 0.0.0.0 when you configure the Secure Gateway Address field
in the Rule Setup screen to 0.0.0.0.
Click the Edit icon to go to the screen where you can edit the VPN rule.
Click the Remove icon to remove an existing VPN rule.
Select this check box to send NetBIOS packets through the VPN connection.
Click Apply to save your changes back to the NBG5715.
Click Cancel to begin configuring this screen afresh.
Chapter 18 IPSec VPN
This field
127