Using A Speakerphone; Using Autoanswer With A Headset Or Speakerphone - Cisco 7940 - IP Phone VoIP Phone Manual

Using a Speakerphone

Many of the actions you can take to dial a number or answer a call will automatically trigger
speakerphone mode, assuming that the handset is in its cradle and
If you want to...
Toggle speakerphone mode on
or off
Switch to a handset
Adjust the volume level for a
call

Using AutoAnswer with a Headset or Speakerphone

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings.
Your system administrator configures AutoAnswer to use either the speakerphone or a headset. You
might use AutoAnswer if you receive a high volume of incoming calls.
If you...
Use AutoAnswer with a
headset
Use AutoAnswer with the
speakerphone
Cisco Unified IP Phone 7960G and 7940G Phone Guide for Cisco Unified Communications Manager 7.0 (SCCP)
Then...
Press to
Lift the handset.
Press
Press Save to preserve the volume level for future calls.
Then...
Keep headset mode active (in other words, keep
when you are not on a call.
To keep headset mode active, do the following:
• Press EndCall to hang up.
• Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are
automatically answered only if
Otherwise, calls ring normally and you must manually answer them.
Keep the handset in the cradle and headset mode inactive (
Otherwise, calls ring normally and you must manually answer them.
Using a Handset, Headset, and Speakerphone
is not lit.
during a call or after invoking a dial tone.
is illuminated.
illuminated), even
unlit).
33