Cisco 7940 - IP Phone VoIP Phone Manual page 30

If you want to...
Remove any conference
participant
End your participation in a
conference
Join together two standard
conferences on the same line
Verify that a conference call is
secure
Remove a non-secure
participant from a conference
Tips
• To start a secure conference, you must use a phone configured with security.
• Non-secure conferences and participants display a
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn or Join.
• Depending on how your phone is configured, if you leave a conference after creating it, the
conference might end. To avoid this, transfer the conference before hanging up.
22
Then...
1. Highlight the participant's name.
2. Press Remove.
You can remove participants only if you initiated the conference.
Hang up or press EndCall.
On SCCP phones, use the
On SIP phones, use the
Check with your system administrator to see if this feature is
available to you.
Look for the or
screen.
While viewing the Conference List, locate the participant without the
or icon, and press Remove.
Check with your system administrator to see if non-initiators of a
conference can remove participants.
Join or DirTrfr softkeys.
Conf or Transfer softkeys.
icon after "Conference" on the phone
icon.
OL-15496-01