Installing The Tape Drive In The Bay - HP C5644A - SureStore Travan T4i Tape Drive User Manual

Installing an Internal Tape Drive

Installing the Tape Drive in the Bay

Installing the Tape Drive in the Bay
1 Slide the tape drive into the open bay. (See figure 2.6.) If your computer uses rails,
align them with the slots or fittings in the bay. Do not secure the drive with screws at
this point because you may have to move the drive a bit to get the cables into place.
Figure 2.6 Fitting the tape drive into an empty bay
Your drive may or may
not use rails to slide into
the empty bay.
2 Attach the SCSI cable to the tape drive, as shown in figure 2.7 and figure 2.8.


Align the raised square on the cable's connector with the slot on the tape drive's
connector.


Press the connectors gently but firmly together.
2-8
Half-height
drive bay