HP C5644A - SureStore Travan T4i Tape Drive User Manual page 35

5 Connect the power supply to the power connector on the back of the tape drive, with
6 Connect the power cord to the power supply and then to a wall outlet or power strip, as
Figure 3.6 Connecting the power supply to the tape drive
Power cord*
*U.S. version is shown. Others may vary.
Note
the arrow on the cable end facing up, as shown in figure 3.6.
shown in figure 3.6.
When you plug in the power supply and attach it to the tape drive, the green light on
the power supply should come on.
There is no power switch on the tape drive. It remains on in standby mode as along as
it is plugged in. It goes into operating mode automatically.
Installing an External Tape Drive
Installing the Tape Drive
Power supply
3-7