Verifying The Installation - HP C5644A - SureStore Travan T4i Tape Drive User Manual

Figure 2.10 Fixing the tape drive in a chassis-mount system
5 Reconnect any internal cables you may have removed from other devices and check
that no cables or boards were knocked loose during installation.
6 If your computer's cover uses blank plates over empty bays, remove the plate that
corresponds to the new tape drive's position.
7 Replace the computer's cover.
8 Reconnect any external cables and power cords you removed.
9 Plug in the computer and peripherals.

Verifying the Installation

Once you have installed the tape drive hardware, you should verify that it is functioning
properly before you store your valuable data. The TapeAssure software on the
HP SureStore Tape CD-ROM will perform a series of tests on the tape drive to verify
that it has been properly installed and provide guidance on what to do if there is a
problem.
1 Switch on the computer and boot it up. If you encounter any problems, refer to Chapter
5, "Troubleshooting."
Installing an Internal Tape Drive
Verifying the Installation
2-11