STMicroelectronics STM32H7B3I-EVAL User Manual page 10

6.3 Embedded STLINK-V3E
6.3.1 Description
The STLINK-V3E programming and debugging tool is integrated into the STM32H7B3I-EVAL Evaluation board.
The embedded STLINK-V3E supports:
• 5 V power supplied by the USB connector (CN21)
• USB 2.0 high-speed-compatible interface
• JTAG and Serial Wire Debug (SWD) specific features:
– 3 to 3.6 V application voltage on the JTAG/SWD interface and 5 V tolerant inputs
– JTAG
– SWD and serial viewer (SWV) communication
• MIPI10 compatible connector (CN16)
• Status COM LED (LD9) which blinks during communication with the PC
• Fault red LED (LD8) alerting on USB overcurrent request
• 5 V/500 mA output power supply capability (U19) with current limitation
• 5 V enabled green LED (LD7)
6.3.2 How to use
It is very easy to use STLINK-V3E to program and debug the on-board STM32.
1. Verify that the power supply source jumper (JP29) is correctly set. Refer to
2. Connect the board to a PC with a USB Type-A to Micro-B cable through the USB connector (CN21).
Note: For more details regarding the STLINK-V3E functionalities, refer to the STLINK-V3E user manual on the
www.st.com website.
UM2662 - Rev 4
UM2662
Hardware layout and configuration
Table 10.
page 10/102