Connecting The Scsi And Power Cables; Figure 7 Sliding The Valueloader Into The Rack Slot, Securing Mounting Bracket - Freecom VALUELOADER DLT User Manual

Tape autoloader

Table of Contents

Installing the ValueLoader

Connecting the SCSI and Power Cables

Figure 7 Sliding the

ValueLoader into the

Rack Slot, Securing

Mounting Bracket

ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual

To connect the SCSI and power cables to the ValueLoader, follow

these steps:

Shut down and turn off the selected server. Turn off all

attached accessory devices, such as printers and other SCSI

devices. Remove the power cables from the server and all

attached accessories.

Failure to remove the power cables from these

Caution:

devices could result in damage to the

ValueLoader.

Attach one end of the SCSI cable (included in the accessory kit)

to one of the connectors on the rear panel of the ValueLoader.

(See

figure

8.)

Table of Contents

Do you have a question about the VALUELOADER DLT and is the answer not in the manual?

Valueloader dlt vs80 Valueloader qdlt vs160