Freecom VALUELOADER DLT User Manual page 57

loaded into the ValueLoader's tape drive while in Sequential
Mode, you may set Circular and Autoload options from the
ValueLoader front panel.
Circular Mode On/Off
and is used only when in sequential mode. When Circular Mode is
on, after the ValueLoader has cycled through all available
cartridges, it then reloads the original first cartridge in the
sequence. If Circular Mode is turned off and the last cartridge has
been unloaded, the ValueLoader stops loading cartridges until you
manually load another cartridge.
Use caution when choosing Circular Mode as it
Caution:
makes it possible to overwrite data on previously
written cartridges.
To access this option, follow these steps:
From the Home screen or main menu, press the
1
until "Configuration" appears on the top line of the LCD
screen.
Press the
2 [Enter]
Press the
3 [+]
LCD screen. The second line on the LCD screen indicates the
current status, either "On" or "Off."
Press the
4 [Enter]
are about to turn Circular Mode on or off.
Press the
5 [Enter]
or
[Cancel]
Autoload Mode On/Off
and is only used when in sequential mode. When Autoload mode
is on, the ValueLoader automatically loads the cartridge from the
lowest numbered full slot into the tape drive when powered on. It
then follows standard sequential operation as described in
Sequential Mode
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
. This option turns Circular Mode on or off,
button to select.
or button until "Circular Mode" appears on the
[–]
button. The LCD screen indicates whether you
button to accept the change to Circular Mode
to exit and not save the changes.
. This option turns Autoload mode on or off,
on page 42.
ValueLoader Administration
Configuring the ValueLoader
or button
[+] [–]
43