Freecom VALUELOADER DLT User Manual page 75

Figure 17 Installing
the Carrier
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
After removing the cartridges from the desired carriers,
9
reinstall each carrier on the ValueLoader belt
• Make sure that the rollers on the bottom of the carrier are
aligned in the carrier tracks.
• Make sure that the belt post beneath each carrier is inserted
into the proper ValueLoader belt loop.
There are unused loops on the belt. The proper belt
Note:
loops have an extra bump on the outside of the loop.
See figure 17
Ensure the carrier is properly installed on the belt by gently
10
pressing on the top of the carrier and sliding it back and forth.
If it is properly attached to the belt, it should not move. If it
moves, reinstall the carrier.
Replace the top cover of the ValueLoader and reinstall the
11
cover screws and mounting brackets (if rackmounted).
Diagnostics and Troubleshooting
Removing Stuck Cartridges
below.
(figure 17).
61