Tools Mode; Overview; Entering And Exiting Tools Mode - Xerox DocuColor 7000AP System Administration Manual

Overview

Entering and exiting Tools Mode

Do c u Co lo r 70 0 0A P /8 0 00 A P S y s t em A d m i ni s tr at i on G u i d e
1.

Tools Mode

The Tools Mode enables you to establish the default settings for
your digital press to fit your individual requirements. You can
change the settings for a variety of features, such as the initial
screen to display when the press is powered on, the language to
display on the Touch Screen, special paper sizes that can be used
in the Paper Trays, timers, audio tone controls, default settings for
scanner features, image quality settings, and more.
KEY POINT: Keep the following in mind as you learn about the
Tools Mode:
• If you attempt to access the Tools Mode while a job is
printing, access to the Tools screens is delayed until the
job completes the printing process.
• Jobs will queue, but will not print while the Tools Mode is
active.
• You cannot access the Tools Mode if the digital press is in
a Fault condition.
• You cannot access the Tools Mode if the Pause key on the
Control Panel was pressed to halt a job. When the halted
job completes the printing process, the Tools Mode may be
accessed.
1-1