Xerox DocuColor 7000AP System Administration Manual page 46

1. To o ls M od e
1- 4 2
• Decurler Penetration Amount: Use this feature to
compensate for paper curl in your output prints. This is the
same as the Decurler Setup feature.
For specific Decurler information, refer to the Decurler Setup
and Decurler E Table Settings section earlier in this chapter.
• Aligner NIP Pressure: Use this feature with paper types
that slip and skew or have damaged edges.
Examples:
– Some coated paper types slip and skew, thereby
having the image misregistered on the output prints. In
this case, you may want to increase the NIP pressure
in order to compensate for the slippage and skewing.
– Some light-weight papers may have too much NIP
pressure applied to them, thereby causing edge
damage to the output prints. In this case, you may to
decrease the NIP pressure.
Do c uC ol o r 7 0 00 A P /8 00 0 A P S y s te m A d mi n i s tr a ti o n G ui d e