Xerox DocuColor 7000AP System Administration Manual page 62

1. To o ls M od e
1- 5 8
10. Evaluate the test prints by holding your 2 Sided output at eye
level near a light source. This will allow you to see the
registration marks for both Side 1 and Side 2 of the output.
a. If you determine that the registration between Side 1 and
Side 2 is significant and needs adjusting, repeat Steps 7-9
until you achieve satisfactory output. Proceed to the Step
11.
b. If the registration between Side 1 and Side 2 is okay, stop
now and proceed to the next step.
11. Once your output is satisfactory, select Close to save these
settings and return to the Alignment Adjustment window.
12. Select Close to save all the settings for this Alignment Profile
and return to the Machine Defaults 2 screen.
13. Close out of Tools Mode.
KEY POINT: The Alignment Profile you just created/modified is
now in affect for the specific Paper Tray that you selected in the
procedure. This Alignment Profile remains in affect until you
reenter Tools Mode and deactivate it. To deactivate an Alignment
Profile, continue to the next page.
Do c uC ol o r 7 0 00 A P /8 00 0 A P S y s te m A d mi n i s tr a ti o n G ui d e