Ptz > Ptz Settings - Vivotek IP8162P User Manual

VIVOTEK
PTZ > PTZ settings
This section explains how to control the Network Camera's Pan/Tilt/Zoom operation�
There are two ways to enable the function:
1� Mechanical: Connect the Network Camera to a PTZ driver or scanner via RS485 interface�
2� Digital: Control the e-PTZ operation� It allows users to quickly move the focus to a target
area for close-up viewing without moving the camera physically� Please refer to page 85 for
detailed instruction�
Mechanical PTZ Operation
RS485 settings
If you select "Mechanical", the RS485 Settings section will be displayed as shown below:
■ Disable: Select this option to disable this function.
■PTZ camera: Select this option to enable PTZ operation.
To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485
interface first. Then you can configure the PTZ driver and RS485 port with the following settings.
VIVOTEK offers three PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, Pelco D protocol, Pelco
P protocol, and Samsung scc643 protocol� If none of the above PTZ drivers is supported by your PTZ
scanner, please select Custom camera (scanner)� Please refer to the user's manual of your PTZ
scanner to determine the Camera ID, PTZ driver, and Port settings� The Camera ID is necessary to
control multiple cameras� If you click Save to enable this function, the camera control panel will be
displayed on the main page� Please refer to the illustration on page 83�
80 - User's Manual
Advanced Mode