Table of Contents
Advertisement
VIVOTEK
Preference
On this page, you can tune the White balance, Image adjustment and WDR enhanced �
Sensor Setting 1:
For normal situations
Sensor Setting 2:
For special situations
White balance: Adjust the value for the best color temperature�
■ Auto: It will automatically adjust the color temperature of the light in response to different light sources.
You may follow the steps below to adjust the white balance to the best color temperature�
1� Set the White balance to Auto�
2� Place a sheet of white paper in front of the lens, then allow the Network Camera to adjust the color
temperature automatically�
3� Check Fix current value to confirm the setting while the white balance is being measured.
■ Manual: This item allows user to input the R gain & B gain manually.
Image Adjustment
■ Brightness: Adjust the image brightness level, which ranges from -5 to +5.
■ Saturation: Adjust the image saturation level, which ranges from -5 to +5. You can also select
Customize and manually enter a value�
■ Contrast: Adjust the image contrast level, which ranges from -5 to +5. Please note that this function will
be disabled if you enable WRD enhancement in the column below�
■ Sharpness: Adjust the image sharpness level, which ranges from -3 to +3� You can also select
Customize and manually enter a value�
■ Gamma curve: This function is for user to select a proper gamma curve value to adjust the gray-scale of
the monitor�
■ Enable low light compensation: Select this option in low light mode, and the values of sharpness and
brightness will change automatically as the noise reduction function�
70 - User's Manual
Advertisement
Table of Contents
