INSTALLATION REQUIREMENTS
WARNING
CAUTION
1. The Air Scrubber
Ozone by activTek
+
installed after the air handler in the HVAC system.
2. The ductwork around the installation area should be
clean and dry to ensure proper adhesion of the gasket
materials and any tape used.
3. When installing near a furnace or heating coils, run the
heating system through the heating cycles to ensure the
temperature of the Air Scrubber
does not exceed 200˚F (93˚C).
4. An approximate 3.5" (8.89 cm) opening will need to be
cut into the existing ductwork to install the unit properly.
NOTE: The Air Scrubber
Do not install where power to the unit will be cycled on and off.
•
Power Connection Requirements: This device is designed to operate
using a 24 VAC, 40Va transformer; transformers supplied with a
straight cooling or HVAC system may be used to power the device
but must be verified it's capable of handling the additional device
load before installation; if the system transformer is not capable of
handing the extra load, a separate
24 VAC, 40Va transformer MUST be used; DO NOT connect the
device to any power source with a voltage less than 22 VAC and a
maximum of 32 VAC; doing so will cause damage to the device
•
If installed near a furnace or where emergency heat coils could raise
the temperature inside the plenum, cycle the AC unit through the
heating cycles assuring that the temperature never exceeds 200°F
(93°C); the activTek
• This unit must be installed by a licensed HVAC contractor or
electrician; failure to do so will void warranty of the product
• When the unit is installed in a roof mounted HVAC system, the unit
must be protected from the elements
• The Air Scrubber
install where power to the unit will be cycled on and off
unit should be
®
Ozone by activTek unit
+
Ozone by activTek
requires power 24/7.
+
®
Cell Assembly must not exceed 200°F (93°C)
®
Ozone by activTek
+
®
Min. 9" x 9" Metal
Ductwork
Min. 10" x 10"
Fiberglass
Ductwork
Air Handle
requires power 24/7; DO NOT
Installation Clearance
Max.
15 ft.
5
Need help?
Do you have a question about the Air Scrubber+ Ozone and is the answer not in the manual?