activTek Air Scrubber+ Ozone Use And Operation page 3

IMPORTANT SAFETY INSTRUCTIONS
WARNING
CAUTION
Read this manual in its entirety before using your Air Scrubber
Keep out of the reach of children.
•
Live voltage may be present
•
Power Connection Requirements: This device is designed to operate using a 24 VAC, 40Va transformer.
Transformers supplied with a straight cooling or HVAC system may be used to power the device but must be
verified it's capable of handling the additional device load before installation. If the system transformer is not
capable of handing the extra load, a separate 24 VAC, 40Va transformer MUST be used. Do not connect the
device to any power source with a voltage less than 22 VAC and a maximum of 32 VAC.
Doing so will cause damage to the device
•
Disconnect power at the breaker or fuse panel before servicing unit; always follow OSHA lockout procedures
to prevent accidental exposure to electrical energy
•
If installed near a furnace or where emergency heat coils could raise the temperature inside the plenum, cycle
the AC unit through the heating cycles assuring that the temperature never exceeds 200°F (93°C);
the activTek Cell Assembly must not exceed 200°F (93°C)
®
•
If the unit is hard wired, be sure the power to the unit is off; always follow OSHA electrical lockout safety
requirements to prevent accidental release of energy during service or maintenance activities
•
Never attempt to check operation of the activTek
can result; check the indicator light on the front face of the unit, if light is On the Cell is working
•
UV Light in operation; disconnect unit from power supply before
servicing; failure to follow warnings may result in severe eye damage
and electrical shock
•
To prevent damage to the unit, operating environment temperature
must never exceed 200
•
DO NOT use this unit with an extension cord
•
To reduce the risk of electric shock, this equipment may have a
grounding type plug that has a third (grounding) pin; this plug will only
fit into a grounding type power outlet; if the plug does not fit into the
outlet, contact qualified personnel to install the proper outlet; DO NOT
alter the plug in any way
•
This unit is equipped with a universal ballast that operates at a nominal
voltage of 24 VAC
•
To Reduce the Risk of Electric Shock – DO NOT use in wet or damp
locations; this equipment emits UV-C radiation; DO NOT locate
equipment in any location allowing direct line-of-sight to vents,
returns, or other duct openings
•
DO NOT connect this unit to any voltage source above 32 volts; doing
so will cause damage to the unit
• Wiring and installation of this unit must be done by a licensed
HVAC contractor or electrician; failure to do so will void warranty of
the product
• When the unit is installed in a roof mounted HVAC system, the unit
must be protected from the elements
• The Air Scrubber
install where power to the unit will be cycled on and off
Location for Protective Earth Line.
SAVE THESE INSTRUCTIONS
F (93 C)
o o
Ozone by activTek
+
Ozone by activTek.
+
Cell Assembly by direct observation; severe eye damage
®
requires power 24/7; DO NOT
®
3