Ruijie Reyee RG-EST450G Installation Manual page 11

Installation Guide
Mark
6
7
Note

After the One-Touch Pairing button is pressed, the wireless bridge is switched to the BaseStation mode
regardless of whether it was in BaseStation or CPE mode.

During one-touch pairing, the signal LEDs on the wireless bridge in BaseStation mode blink for 1 minute
(it will stop blinking after 1 minute if no bridge connection is established). The signal LEDs on the bridge
in CPE mode also blink until the pairing is complete.

Only a bridge that has been reset to factory settings and has not been bridged before can be switched to
the CPE mode through one-touch pairing.

The one-touch pairing feature is enabled by default and can be disabled through eWeb.

One-touch pairing is disabled during interference scanning.
Table 1-3 LEDs
LED
System LED
LAN1/LAN2/LAN3
port LED
Signal LEDs
Item
Reset/One-Touch Pairing
button
Label
Status
Solid green
Blinking
Off
Solid green
Blinking green
Off
Off
LED 1 on/blinking
Description
Press and hold the button for less than 2s: The
wireless bridge pairs with another wireless bridge (the
LED blinks during pairing).
Press and hold the button for 2s to 10s: No action is
triggered.
Press and hold the button for more than 10s: Restores
the wireless bridge to factory settings.
Contains the product name, model, I/O parameters, default
IP address, and other information.
Description
The device is operating normally.
Fast blinking (8 to 10 times/second): The device is
starting up.
Fast blinking (2 times/second): The device is
initializing.
Fast blinking (2 times/second): The device is
upgrading.
The device is NOT receiving power.
A valid link is established, but the port is not receiving or
sending data.
A valid link is established, and the port is receiving or
sending data.
No link is established.
The device is not bridged.
The device is bridged and the RSSI is below –75 dBm.
5
Product Introduction